真空熔煉爐常見的故障及處理方式 真空熔煉爐在使用長時間后會出現一些故障,這是在所難免的。今天八佳小編就和大家說說當故障出現,要做哪些處理方法。 1、故障現象:真空熔煉爐運行正常,但在正常過流保護動作時燒毀較多的是KP晶閘管和快熔。 分析處理:過流保護時為了向電網釋放平波電抗器的能量,整流橋由整流狀態轉到逆變狀態,這時如果α>120度;,就有可能造成有源逆變顛覆,燒毀多只晶閘管和快熔,開關跳伴隨有巨大的電流短路爆炸聲,對變壓器產生較大的電流和電磁力沖擊,嚴重時會損壞變亞器。 2、故障現象:真空熔煉爐運行正常,但在高電壓區內某點附近設備工作不穩定,直流電壓表晃動,設備伴隨有吱吱的聲音,這種情況極容易造成逆變橋顛覆燒毀晶閘管。 分析處理:這種故障較難排除,多發生于設備的某部件高壓打火: (1)真空熔煉爐的連接銅排接頭螺絲松動造成打火 (2)斷路器主接頭氧化導致打火; (3)補償電容接線樁螺絲松動,引起打火,補償電容內部放電阻容吸收電打火; (4)水冷散熱器絕緣部分太臟或炭化對地打火; (5)真空熔煉爐爐體感應線圈對爐殼/爐底板打火,爐體感應線圈匝間距太近,匝間打火或起弧。固定爐體感應線圈的絕緣柱因高溫炭化放電打火 (6)晶閘管內部打火。 以上就是真空熔煉爐廠家分析的兩種常見的故障。大家明白了嗎(ma)?如果還有不明白,也可以打電話咨詢。